Handmade Music Clubhouse

Cigar Box Guitar Headquarters - CBG HQ

Hi makers. I am looking at making the Don Tillman preamp circuit available as a printed board for those who don't have experience in soldering up circuits. I've found the Tillman circuit to be very good for piezos and adding a preamp will make it the right impedance for amps and mixing boards while greatly improving the tone and output level. It also means you can add a proper tone control using a 25k pot and the usual cap. The board I have printed includes extra cap and resistor for greater FET tolerances, a tone/boost option, and a volume adjustment for matching a piezo with a mag pickup or bringing the output down (the Tillman gives plenty of level from a disc piezo and can be a little hot for some inputs).

The clearly labelled board alone would be $10 and the parts are easy to get. Board plus parts ready to solder in would be $20. Fully assembled - just needs the piezo, battery and outputs soldered on - would be $30. (Piezo, 25k pots, output jack, battery and battery holder not included).

Would come with set of instructions.

Any interest out there? I'd need to see a bit of demand to justify getting a sheet of them printed up.

cheers and Happy New Year

Glenn

Views: 1062

Replies are closed for this discussion.

Replies to This Discussion

Mike - it would come to about $30 AUD.  Still not sure if I'll do them. Getting a print done is very expensive and I'd have to sell heaps of them to get my outlay back.

ok - will wait and see what happens , mike

What is the shipping to the uk Glen,

Andrew, I did all the sums and it just isn't worth it. The cost of printing out 100 circuits on a slab of board is too much.  I have an elec engineer bud who sneaks the circuits onto the edges of prototype boards he gets printed, but doing a whole one of those myself  is  very marginally profitable. I can make more in one gig.  Sorry for the false alarm. I'll take this whole thread down in a couple of days.

No problem Glenn.thanks

RSS

© 2020   Created by Ted Crocker.   Powered by

Badges  |  Report an Issue  |  Terms of Service