Is it possible to make worm drive tuners, using only handtools?
I think so, and I have tried to make worm drive tuners, one smaller, and one bigger, but they are both much bigger than ordinary worm drive tuners (machine heads).
The worm itself is not made by using a lathe and carving away the redunt materials.
Instead an add-on method is used, where a cord is wrapped around a dowel, and some nails keep it in place.
The worm wheel uses nails or wire as »teeths«.
Two kinds of dowels are used.
The thin axis is made of a Ø6 mm thick flower stick. The thick axis is made of a Ø22 mm broom stick.
The worm drive tuners are very big, so they are placed on the instruments body and not on the headstock.
You can share this photo in two ways…
Share this link:
Send it with your computer's email program: Email this